Choose Car Type


then
Search for parts
or
Browse for parts

 

BONNET HINGE PAIR TR3-3B CHROME PLATED

Part No:
650021/22
Price
£55.44
Price Ex VAT @ 20%
£46.20

AVAILABLE This part is available to order

These Bonnet Hinges fitted to the TR3 from TS8637 (the beginning of TR3 production to end of TR3B production) are a pressure die casting chrome plated. This product is of poor quality with invariably a very loose hinge pin.

The loose pin produces an irritating panel rattle that is particularly obvious (and irritating) at idle.
As the material is highly prone to corrosion the hole in which the pin sits will quickly corrode leaving an oval hole for the pin to rattle in even if the pin was tight when new.

Pressure die casting produces a skin with a sponge like interior. This makes it weak and likely to snap at the hinge point if overstressed. These hinges are difficult to restore too as the material corrodes like a 'blue cheese' making it almost impossible (and very expensive) to re-plate.

In addition, as the material is soft, it is quite common for the attachment studs to be pulled out of the casting when the nuts are tightened on installation. If this happens there is no solution other than to throw the hinge away and replace it.

Given all of the above Revington TR recommend 650023HQ, 650024HQ, 650023HQK a much higher quality gravity die cast hinge with stainless steel hinge pins; available singularly and as pairs.

Important Note:-These hinges are handed so ensure you fit them to the correct side. Incorrect fitment will lead to a very quick failure at the hinge point of these pressure die cast hinges.


To view the Triumph Catalogue Plates, please pick a car type