Pair of large boot hinges suitable for replica TR4 works rally cars. This part number covers the type of hinges used on the works TR4 rally cars. We make these hinges to special order but they are far from cheap. we have however an alternative which is slightly shorter but looks much the same. Please order part number RTR7117-1.See below

Original Stanpart hinges are very hard, to near impossible to find new or second hand (they were used chromed and painted on Standard Vanguards and Ensigns) hence we offer these remanufactured parts and the cheaper alternative below. 

 

The type of hing used on the works cars (part number RTR7117) is substantially longer (252mm long) than the TR4 standard hing and is in fact normal fitment on a Standard Ensign or Vanguard. The longer hinges were employed for a specific purpose, in that the lightweight aluminium boot lid needed extras support and from time to time an additional spare wheel was carried on the boot lid adding additional strain to the hinges. 

As we have original samples we can have these cast and finished with chrome plating to a high standard if the original look of the works TR4 rally car is required. As we supply these infrequently the cost shown here will be confirmed or updated on request.

A much more practical solution is the readily available hing listed below RTR7117-1, whist a little shorter it will do the job and look correct to the casual eye.

This part is listed on the following page of the website, where further information and background reading may be found.

Chassis and bodywork » REPLICA RALLY TR4 BODY PARTS AND GENERAL IMPROVEMENTS