Engine, Transmission, wheels/Tyres and Heating/Cooling
- Browse Modified, Uprated & Alternative Parts
- CLICK TO VIEW
TRIUMPH PLATES - Browse Original Triumph Catalogue Plates
PUSH RODS
Many gains in power and reliability in an engine can be achieved by careful building. When the rocker gear is installed, the rocker motion should result in the rocker being at 90° to the pedestal at half lift. To achieve this, the pedestal is either raised with shims, or the under-face machined off. This exercise will invariably result in the push rod ball pins being out of adjustment, requiring different length push rods. We therefore offer the push rods listed below to correct this situation. The push rods are measures in length overall. We appreciate that the correct way to measure would be from the centre of the ball end to the centre of the cup but as this is impractical an overall dimension gives an adequate indication of what will work in an individual application.NOTE: For reference a TR250-6 Carb standard length is 211mm and TR5-6PI standard length is 206mm
| Part No. | Description and Comments | Price | Add to Cart | |
|---|---|---|---|---|
 |
RTR1190
|
PUSH ROD 262mm O/A TR2-4ARevington TR information: TR2-4A tubular push rod, length 262mm overall, of the type where the main shaft can be parted off with the cap in situ so that the cap can be pushed down into the tube to suit... READ MORE |
£18.00 Ex VAT @ 20% |
|
|
RTR1189
|
PUSH ROD STD 260mm O/A Eff 253mmRevington TR information: TR2-4A tubular push rod standard length: 260mm Many gains in power and reliability in an engine can be achieved by careful building. When the rocker gear is installed, the rocker motion should result in the rocker... READ MORE |
||
|
RTR1155
|
PUSH ROD CH MOLY TR2-4A EACHRevington TR information: TR2-4A Chrome Molybdenum Steel push rods. Length 275mm. These Push Rods are supplied with the lower ball end fitted and the top cup loose. This allows the fitter to trim the rod to the correct length... READ MORE |
£51.24 Ex VAT @ 20% |
