Hardware, Oils and consumables

CLEVIS FORKS

Revington TR's generic numbering system allows for easy identification of fastener products from their part number.
All clevis forks are prefixed CF.

• The first number indicates the units of measurement as follows:- 1 = English 2= Metric
• The second number indicate thread diameter in 16ths of an inch or 1.00mm increments. UNF or standard Metric pitch is assumed
• The length is indicated by the 3rd and 4th numbers and is measured from centre line of the clevis pin to the end of the threaded section in 16ths of an inch or 1mm increments
• The 5th number indicates the internal width of the clevis, measured in 16ths of an inch or 5.0mm increments.
• The 6th and 7th numbers are the diameter of the clevis pin expressed in 64ths of an inch or 0.1mm 
• The 8th and last number is reserved for variations, where 1 = BZP, 2 = black and 9 = special
• the letter K after the part number indicates an assembly of the clevis fork, sold with its clevis pin and the pin retainer (split pin of clip)